Troubleshooting
Reinstall missing or unresponsive imaging unit [31.xy]
Try one or more of the following:
•
Check if the imaging unit is missing. If missing, install the imaging unit.
For information on installing the imaging unit, see the "Replacing supplies" section of the User's Guide.
•
If the imaging unit is installed, then remove the unresponsive imaging unit, and then reinstall it.
Note: If the message appears after reinstalling the supply, then the imaging unit is defective. Replace the
imaging unit.
Remove defective disk [61]
Remove and replace the defective printer hard disk.
Remove packaging material, [area name]
Remove any remaining packaging material from the specified location.
Remove paper from all bins
Remove the paper from all of the bins. The printer automatically senses paper removal and resumes printing.
If removing the paper does not clear the message, then touch Continue.
Remove paper from bin [x]
Remove the paper from the specified bin. The printer automatically senses paper removal and resumes printing.
If removing the paper does not clear the message, then touch Continue.
Remove paper from [linked set bin name]
Remove paper from the specified bin. The printer automatically detects paper removal and resumes printing.
If removing the paper does not clear the message, then touch Continue.
Remove paper from standard output bin
Remove the paper stack from the standard bin.
Replace all originals if restarting job.
Try one or more of the following:
•
Touch Cancel job to clear the message and cancel the scan job.
•
Touch Scan from automatic feeder to continue scanning from the ADF immediately after the last successful scan
job.
•
Touch Scan from flatbed to continue scanning from the scanner immediately after the last successful scan job.
310