Other Setups; Subwoofer Remix -"Subw Re-Mix; Crossover -"Crossover; Lfe (Low Frequency Effect) Level -"Lfe Level - Kenwood KRF-V7300D Instruction Manual

Other setups

Subwoofer Remix –"Subw Re-Mix"– Subwoofer Remix –"Subw Re-Mix"–
Mixes the bass tone of other channels to the subwoofer channel.
1
Select "Subw Re-Mix".
[SETUP]
[MULTI CONTROL 2/3]
[ENTER]
2
Set the Subwoofer Remix.
Use [MULTI CONTROL ∞/5] to select whether or not
Subwoofer Remix is used.
[ENTER]
Display Setting
"SW RE-MIX On" Sets Subwoofer Remix to ON.
Sets Subwoofer Remix to OFF.
"SW RE-MIX Off" In this case, the bass frequencies are output only from the front
speakers.
• Subwoofer Remix cannot be setup if the Subwoofer is set to
"SUBW Off" or the Front speakers are set to "FRNT Normal".
38
KRF-V9300D/KRF-V8300D/KRF-V7300D
Crossover –"Crossover"– Crossover –"Crossover"–
The crossover frequency is the lower limit of the bass frequencies
reproduced from the speakers set to "Normal" in the <Speaker
configuration –"SP Setup"–>. The frequencies below the set
crossover frequency are output from other speakers (those set to
"Large" and the subwoofer).
1
Select "Crossover".
[SETUP]
[MULTI CONTROL 2/3]
[ENTER]
2
Set the crossover frequency.
Use [MULTI CONTROL ∞/5] to select crossover frequency.
[ENTER]
The frequency is selected from 40Hz to 200Hz in10Hz step.
LFE (Low Frequency Effect) level LFE (Low Frequency Effect) level
–"LFE Level"– –"LFE Level"–
Low frequency effect signal is used exclusively for giving the field
effect of bass tone in the Dolby Digital and DTS signal.
1
Select "LFE Level".
[SETUP]
[MULTI CONTROL 2/3]
[ENTER]
2
Set the LFE level.
Use [MULTI CONTROL ∞/5] to select the LFE level.
[ENTER]
The level is adjusted from 0dB to -10dB in1dB step
decrements.