Setting The Oneremote Volume Option - OneRemote RMB4 User Manual

Setting the OneRemote Volume Option

When the t key is pressed, the Panasonic TV is powered up automatically
and turned on in the TV mode.
If a Bang & Olufsen audio master is in the room, it is possible to use it for
handling the sound. Below options determine how the One Remote RMB4
handles volume in the TV mode.
This option also allows for the power up other B&O devices than the TV, when
t is selected. The audio signal from the TV is wired to the audio master
using a Line to Datalink cable. Moving the TV sound to the speakers of the
audio master improves the sound quality significantly.
Volume Options
Enter one of these option sequences
within 10 seconds:
mq00w
mq01w
mq02w
mq03w
is pressed the Beo4 it sends a Power On command to the TV. At the same time the Beo4 sends a B command to a Bang & Olufsen
*1 When t
audio master. Until another source is selected, volume commands will be directed to the B&O audio master.
t
*2 When is pressed the Beo4 sends a Power On command to the TV. At the same the Beo4 sends a
system. Until another source is selected, volume commands will be directed to the B&O system. Via a BeoLink Active sound may be moved from the TV
to PowerLink speakers.
www.oneremote.dk
Sound Destination
Alternative speakers.
Volume disabled
The Panasonic TV
*1
B
*2
Volume Control
Volume data format emitted
from Beo4.
No volume control
Panasonic format
B
in B&O format
c
in B&O format
command to a Bang & Olufsen
Page 8