Advertisement
Option programming
The OneRemote EXT controller can be programmed with different options, to fit different set ups.
An option programming is done by pressing a series of buttons in a special scheme that does not occur
during daily use. A programming must be ended within 10 seconds.
To abort an ongoing programming sequence, press any other button than
to
.
0
9
Power off option.
In some cases it is not wanted that the device automatically powers off, when the TV is powered off. Use
this option to enable or disable this.
qqqqqq70
qqqqqq71
Menu option.
Some B&O TVs not only echoes the MENU button from the remote control to the device attached to the
Scart socket. It also opens the TV's own ON-screen menu. Use this option to avoid that the device acts on
this command, if your setup has this conflict.
qqqqqq81 Use the MENU button.
qqqqqq80 Ignore the Menu button..
Zap mode option.
The zapmode option makes it possible to exchange the functions of the up & down buttons with the blue &
yellow buttons. The factory setting of programme zapping and up/ down arrows:
W
D and F
While using a Beolink 1000 or other older remote control without coloured buttons, it is a little awkward to
make a programme zap when option 91 is set. This option reverses the use of the sets of arrows.
w w w . o n e r e m o t e . d k
R
and
Programme zapping.
Moving up/ down in on-screen menus.
or the numeric buttons
q
Device never powers off.
Device powers off with TV.
Page 5
Advertisement
