Table of Contents
Advertisement
Programme Zapping option
In a BeeLINK environment the
up and down in an on screen menu.
This is the basic OneRemote layout and compatible with other OneRemote controllers.
Some people prefer the programme zapping buttons on the up and down buttons. The programme zapping option,
make it possible to change the function of these buttons.
If the user would give it a fair chance, trying out the OneRemote layout, it is not likely that he would make use of this
option. The OneRemote layout adds much perspective to many OSD menus on many devices, and makes sense once
fully understood. But we are up against habits, which we all wants to hang on to, so...
Option
Function
W
R
090
and
D
F
091
and
An option programming sequence is initiated by pressing the little red switch on the BeeLINK2 controller, until its LED starts flashing. Hereafter the
3 digit option code must be entered with the B&O remote control.
Menu button option
If the device is used in a setup that includes a Bang & Olufsen TV, sometimes the use of the
conflict.
Some Bang & Olufsen TV act on the
to.
In these setups the Menu button must be disabled on the BeeLINK controllers. Instead of using the Menu button to
access the devices 'Menu', use the alternative menu operation
Option
Function
080
Menu button blocked. Use alternative menu operation
081
Menu button enabled.
An option programming sequence is initiated by pressing the little red switch on the BeeLINK2 controller, until its LED starts flashing. Hereafter the 3
digit option code must be entered with the B&O remote control.
w w w . o n e r e m o t e . d k
and Rare being used for programme stepping and to manoeuvre
buttonsW
are used for Bouquet+/ Bouquet-. Factory setting.
are used for Bouquet+/ Bouquet-.
and enters its own TV On Screen Menu regardless of which source it is set
m
o5
.
m
button gives a
Page 8
Advertisement
Table of Contents
