Table of Contents
Advertisement
Switching to AVCHD mode
Use the steps below to switch to AVCHD mode.
1
Press the MODE (SHIFT+REMOTE) button to open
the mode select menu.
◆ NOTE:
• AVCHD display and selection are available only when setup
menu No. 25 (SYSTEM FREQ) is set to 50 or 59.94.
2
Select AVCHD from the menu.
The LCD monitor shows thumbnails of each SD memory
card clip. (If there are a large number of clips, it may take
time to display them all.)
The thumbnail screen allows you to do the following.
• Play back, repair and delete clips
• Add and delete shot marks
• Formatting SD memory cards
Basic thumbnail screen operations
■ Selecting a thumbnail
Use the cursor buttons to select thumbnails.
(The yellow frame moves.)
■ Playing back clips
Select a thumbnail and press the PLAY button.
(For details of playback, refer to "Playing Back AVCHD Clips"
(page 169).)
162
AVCHD Recording and Playback: Using an Optional AVCHD Board
■ Opening menus
Press the MENU button when thumbnails are displayed.
2
1)
2) 3)
4)
6)
5)
1)
Thumbnail display status (➝ page 163)
Displays the type of clips that displays thumbnails.
2)
Repeat play indicator (➝ page 168)
Indicates that repeat play is on.
3)
Card status indicator (➝ page 165)
Displays SD memory card status.
4)
Record mode indicator
Indicates the recording mode of the clip at the cursor
location.
5)
Cursor (yellow frame)
Appears around the selected thumbnail.
6)
Recording format indicator
Indicates the recording format of the clip at the cursor
location.
7)
Duration indicator
Indicates the duration of the clip at the cursor location.
8)
Time indicator (➝ page 163)
Depending on setting, this will show time code/user bit
at start of clip recording, time of shooting, day of
shooting or date and time of shooting.
9)
11)
7)
8)
10)
Advertisement
Table of Contents
