Names And Functions Of Parts - Kenwood KRF-V4550D Instruction Manual

Names and functions of parts

Speakers' indicator
MUTE indicator
RDS indicators
1 POWER key
Use to switch the main power ON/OFF.
2 ON/STANDBY (
) key
Use to switch the power ON/STANDBY when
the POWER is turned ON.
STANDBY indicator
3 MULTI CONTROL key
Use to control a variety of settings.
4 SET UP key
Use to select speakers' settings etc.
5 Surround indicators
DOLBY DIGITAL indicator
Lights when the receiver is in the Dolby
Digital mode.
PRO LOGIC indicator
Lights when the receiver is in the PRO LOGIC
mode.
3 STEREO indicator
Lights when the receiver is in the 3 STEREO
mode.
6 INPUT MODE key
Use to switch between the digital and analog
inputs.
Standby mode
While standby indicator is lit, this receiver is in standby mode and consumes a small amount of current for back-up. This system can be switched ON by using the remote
control.
Frequency display,
Input display,
Preset channel display,
Surround mode display
Speaker selection indicators
Input channel indicators
Output channel indicators
^ 7 DIMMER key
Use to adjust the brightness of the display.
^
Use to select the REC MODE.
8 MONITOR key
Use to monitor the source that is connected
to the VIDEO2/MONITOR jack.
9 VOLUME CONTROL knob
^
0 PHONES jack
^
Use for headphone listening.
! SPEAKER key
Use to turn the speaker ON/OFF.
§
MUTE key
Use to temporarily mute the sound.
@ SOUND key
§
Use to adjust the sound quality and ambience
effects.
# BAND key
§
Use to select the broadcast band.
$ AUTO key
Use to select the auto tuning mode.
% LISTEN MODE key
7
Use to select the listening mode.
AUTO SOUND indicator
Band indicators
DOWN MIX indicator
3 STEREO indicator
STEREO indicator
Display
)•
(
*
(
&
(
¶
¡
¡
§
PRO LOGIC
indicator
DIGITAL indicator
S.DIRECT indicator
AUTO indicator
MEMO. indicator
ST. indicator
TUNED indicator
MONITOR indicator
^ MEMORY key
Use to store radio stations in the preset
memory.
& SOURCE DIRECT key
Use to pass the source material direct to the
amplifier.
* INPUT SELECTOR knob
Use to select the input sources.
5
™
(
*