Loading Paper - Sharp MX-C250 Operation Manual

LOADING PAPER

Make sure that the machine is not copying or printing, and then follow these steps to load paper.
Loading the paper tray
1
Gently lift and pull out the paper tray until it stops.
2
Push the pressure plate down, and adjust the plates in the tray to the length and width
of the paper.
(2)
(1)
(2)
Plate B
Plate A
3
Load paper into the tray.
Roller
Protrusion
4
Gently push the paper tray into the machine.
(1) Push the center of the pressure plate down until it locks into place.
(2) The plate A and B are slide-type guides. Grasp the locking knob on the
guide and slide the guides until the width that the paper can be loaded
properly.
(2)
• Open the package of the paper and load it without fanning the paper.
• Make sure the stack of paper is straight before loading it.
Line on
the guide • After loading the paper, close the guides to the paper width not to leave the
gap from the guides.
Note
Push the tray in completely.
Note
• Do not load paper higher than the line on the guide (up to 250 sheets).
• Do not add paper to the loaded paper. It may cause multiple feed of
paper.
• The loaded paper should not go higher than the protrusion of the plate A.
• If you loaded a different size of paper than was loaded previously in
the tray, go to "CHANGING THE PAPER SIZE SETTING OF A TRAY"
(p.22).
• When misfeed occurs, rotate the paper 180 degrees and reload it.
• Straighten curled paper before using it.
19
BEFORE USING THE MACHINE