Misfeed In The Machine - Sharp MX-C250 Operation Manual

MISFEED IN THE MACHINE

To remove a misfeed from inside the machine, open the side cover, check whether the misfeed occurred in "A", "B",
or "C" below, and follow the misfeed removal procedure.
1
Open the bypass tray and the side cover.
2
Check the misfeed location. Remove the misfed paper following the instructions for
each location in the illustration below.
Area B
If the misfed paper is visible
here, go to "Misfeed in the
fusing area B" (p.157).
Area A
If paper is misfed here, go to
"Misfeed in the paper feed
area A" (p.156).
Misfeed in the paper feed area A
1
Carefully remove the misfed paper. Turn the roller rotating knob in the direction of the
arrow to assist in removing it.
Roller rotating knob
2
Close the side cover.
The message " Clear paper path." will be cleared and copying will be possible.
• When closing the side cover, press on around the handle.
Note
• If the message does not clear, check again to make sure that no pieces of paper remain.
Note
Fusing unit
If paper remains in the bypass tray, remove the paper.
Be careful not to tear the misfed paper during removal.
The fusing unit is hot. Do not touch the fusing
Warning
unit when removing misfed paper. Doing so may
cause a burn or injury.
When removing misfed paper, do not touch or damage
Caution
the transfer belt.
156
TROUBLESHOOTING
Area C
If paper is misfed here, go to
"Misfeed in the transport area C"
(p.158).