Connection And Installation - TP-Link CPE210 Installation Manual

2. Connection and Installation

Please connect and install the device as shown in the fi gure below.
LAN0
Ethernet cable length up to 60m
Slide to replace the cover
of the CPE when all
connections are fi nished.
5
You should prepare an adequate
Ethernet cable to connect the CPE
and the passive PoE adapter.
Shielded CAT5e (or above) cable
with ground wire is recommended
(refer to the next section).
POE LAN
At the selected site,
approximately align the
CPE to the direction that
you have oriented.
Connect to a computer,
router or switch.
(Depending on your
intended usage and/or
network topology.)