Point-To-Multipoint - TP-Link CPE210 Installation Manual

• Point-to-Multipoint

Point-to-Multipoint application is used to serve Internet access for
multiple locations from a single Access Point. There are many types of
configurations to provide this service. Here we introduce the ISP-style
(Internet Service Provider along with subscribers) Point-to-Multipoint
application, as shown in the figure below.
Internet
Router
LAN: 192.168.7.1
Refer to the following steps to configure the CPEs.
When making the configuration for the CPE of the subscribers, please
contact the ISP for related information, as the configuration may vary due
to different ISPs.
Configure the Access Point (a typical configuration for
Internet Service Provider):
1. Log in to PharOS
2. Go to the Quick Setup page
3. Operation Mode
• Select 'Access Point' .
• Click 'Next' .
13
Access Point
LAN: 192.168.7.2
AP Client Router
LAN: 192.168.0.254
WAN: Dynamic IP
AP Client Router
LAN: 192.168.0.254
WAN: Dynamic IP
AP Client Router
LAN: 192.168.0.254
WAN: Dynamic IP