Configuration For Typical Applications; Point-To-Point - TP-Link CPE210 Installation Manual

2. Configuration for Typical Applications

This section introduces the configurations for the point-to-point,
point-to-multipoint and hotspot applications. Refer to the section
corresponding to your networking needs.

• Point-to-Point

Point-to-Point application is used to build a transparent bridge
between two locations which are far from each other. The figure shown
below is an example for this application.
Computer
Refer to the following steps to configure the CPEs.
Configure the Access Point
1. Log in to PharOS
2. Go to the Quick Setup page
3. Operation Mode
• Select 'Access Point' .
• Click 'Next' .
4. LAN Settings: Click 'Next' .
5. Wireless AP Settings
• SSID: customize the name for the network as you like.
• Security: select 'WPA-PSK/WPA2-PSK' .
• PSK Password: create the password for the network as you like.
• Distance Setting: enter the distance between the Access Point and
the Client. It is recommended to round the number up to the
nearest integer.
• Select the MAXtream option if the Access Point and the Client
both are Pharos outdoor CPEs. (Refer to 'Q4' in 'FAQ' for details about
MAXtream)
• Click 'Next' .
6. Finsh: Click 'Finish' .
11
Access Point
LAN: 192.168.0.254
Client
LAN: 192.168.0.2
IP camera