Sewing Buttons - Husqvarna Lily 555 User Manual

Sewing buttons

1. Mark the fabric where the button
is to be located.
2. Model 555: Select
display will recommend to lower
the feed teeth. See page 16.
3. Model 545: Select zigzag
Lower the feed teeth with the dial.
See page 16.
4. Snap off the presser foot.
5. Place the material under the press-
ser foot ankle.
6. Place the button on marking and
lower the presser bar so that the
presser foot ankle is between the
holes of the button (see picture).
7. Hold the thread ends to one side.
Turn the handwheel and check to
be sure that the needle goes into
the left hole of the button.
8. Touch the mirroring button
check that the needle also goes
into the right hole. If you have
a button with a different hole
spacing, you can adjust this by
presssing one of the stitch width
buttons (+) or (-).
Button with a shank
Use the clearance plate for this pur-
pose. Use the thin end when sewing
buttons on light fabrics, the thick
end for heavier fabrics.
Push in the plate between the but-
ton and the fabric. Lower the presser
bar and sew on the button.
Pull the threads between the button
and the fabric.
Wind the threads a few times around
the shank and tie the ends.
32
. The Info-
.
9. Sew as many stitches as you con-
10. Model 555: Touch
11. Touch STOP to cancel it. Move
to
sider necessary.
Model 545: Touch STOP.
The machine will then tie off in
one of the holes and stop.
to the next pair of holes or the
next button.
Model 555: To repeat, touch
STOP, see page 27.
Instruction book Lily 555/545
.