Bobbin Winding With The Machine Threaded - Husqvarna Lily 555 User Manual

Bobbin winding with the machine threaded

Make sure that the presser foot is up and the needle is in the highest posi-
tion.
Note! Do not use a plastic presser
foot when bobbin winding.
1. Place your empty bobbin with the
small mark outwards on the
bobbin spindle on the front of the
machine.
2. Pull the thread from the needle under
the presser foot and to the right over
the thread guide (c).
3. Start from above and wind a few
turns of thread around the bobbin.
Cut off the thread on the thread knife
(d).
Bobbin winding - vertical spool pin
1. Place an empty
bobbin with
the mark
out-wards on the
bobbin spindle
on the front of
the machine.
2. Place the large
spool holder under the thread
on the spool pin.
3. Bring the thread under the th-
read guide (a) and over thread guide
(b), then around thread guide (c) as
illustrated.
12
4. Bring the bobbin spindle down.
Press the foot control. When the
bobbin winding is fi nished, the
bobbin will stop automatically.
Remove the bobbin, cut off the
thread and bring the bobbin
spindle up.
Note! We do not recommend win-
ding specialty threads such as clear
nylon or other stretchy threads th-
rough the needle. Instead see "Bob-
bin winding - vertical spool pin".
5. Bring the bobbin spindle down.
Press the foot control. When the
bobbin winding is fi nished, the
bobbin will stop automatically.
Remove the bobbin, cut off the
thread and bring the bobbin
spindle up.
Instruction book Lily 555/545
4. From above
wind a few
turns of
thread
around the
bobbin and
into the knife.