Temporarily Blocking Remote Transmission Of Alarms; Temporarily Blocking Remote Transmission Of Alarms & Faults - Siemens FC10 Operating Instructions Manual

Fire detection control unit
Table of Contents

Advertisement

Operation
5.6.6

Temporarily blocking remote transmission of alarms

5.6.7
Temporarily blocking remote transmission of alarms & faults
24
Siemens Building Technologies
Fire & Security Products
Overview
If in exceptional cases alarms shall not be remotely transmitted, the remote trans-
mission of alarms must be blocked.
Remote transmission functions that have been blocked are not activated in case
WARNING!
of an alarm! For this reason, always enable blocked remote transmission func-
tions again as soon as normal operating conditions are prevailing again!
Procedure
To block the remote transmission of alarms, please proceed as follows:
1. Enable the operating level 2 (password or key).
2. Press the key 'RT-ALARM Disable/Enable' twice.
The yellow LED 'RT-ALARM' lights up.
The remote transmission of alarms is now blocked and you can carry out the
intended work.
3. To switch the remote transmission of alarms on again, press the key 'RT-Alarm
Disable/Enable' twice.
The yellow LED 'RT-ALARM' no longer lights up.
The remote transmission of alarms is enabled again.
Overview
If in exceptional cases alarms or faults shall not be remotely transmitted, the re-
mote transmission of alarms and faults must be blocked.
Remote transmission functions that have been blocked are not activated in case
WARNING!
of an alarm or fault! For this reason, always enable blocked remote transmission
functions again as soon as normal operating conditions are prevailing again!
Procedure
To block the remote transmission, please proceed as follows:
1. Enable the operating level 2 (password or key).
2. Press the key 'RT-ALARM Disable/Enable' three times.
The yellow LEDs 'RT-FAULT' and 'RT-ALARM' light up.
The remote transmission of alarms and faults is now blocked and you can
carry out the intended work.
3. To switch the remote transmission on again, press the key 'RT-ALARM Dis-
able/Enable' once.
The yellow LED 'RT-FAULT' and 'RT-ALARM' no longer light up.
The remote transmission of alarms and faults is enabled again.
007995_a_en_--.doc
04.2004

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents