Understanding The Control Panel - Indesit WME 6 X Instructions For Installation And Use Manual

Here I'm in command
Making the right choice is important. And it's easy.
Programme selector knob
Use this knob to select the wash
programme.
Turn this knob clockwise
only.
To select a programme, you
should turn the knob so that the
symbol/number of the desired
programme is in line with the
pointer on the knob.
Now press on/off button G
(position ), pilot lamp H will start
flashing.
After 5", the setting will be
accepted, pilot lamp H will stop
flashing (staying lit) and the
wash cycle will begin.
Should you wish to interrupt the
programme in progress or set a
new one, select one of the
symbols (Stop/Reset) and
wait 5" : when the cancellation
has been accepted, pilot lamp
H flashes, and you can then turn
the appliance off.
After the wash cycle has been
set and accepted by the
washing machine, turning the
knob will have no effect (except
for when it is on position
Reset).
19
Temperature control knob
It is used to set the wash tempe-
rature in the recommended
programme table on pag. 20. It
also allows you to reduce the tem-
perature recommended for the
selected programme, and even to
set a cold wash cycle ( ).
Detergent dispenser
It is divided into three
compartments:
1. Detergent for pre-wash;
2. Detergent for the main cycle
wash;
3. Fabric conditioner.
Easy iron
This function allows your
washing to come out of the
machine without creases,
making it much easier to iron.
You can use it with programmes
3-4 (Cotton), 5-6 (Synthetics)
and 8-9 (Delicates).
Press this button
programmes 5-6-8-9 and the
Stop/ wash cycle will come to a stop
on symbol . You can comple-
te it by pressing button D again.
1
3

Understanding the control panel

C
Spin Exclusion
Press this button and the washing
machine will not carry out a spin
cycle, but rather a drum spin at
medium speed to assist water
draining. We recommend that you
use it when washing garments
which are difficult to iron.
Extra Economy
Reduces water consumption
during the rinse cycles. We
recommend that you use this
function only with small laundry
loads, dosing the detergent
proportionally.
On-off
When button G is pressed, the
washing machine is switched
on, when it is not the machine
is switched off.
Turning the appliance off
does not cancel the selected
programme.
in
The on-off lamp
Lamp H flashes when the
appliance is switched on and
awaiting a programme to be set.
A steady light means the
appliance has accepted the
selected programme.
The door block lamp
The safety lamp indicates that
the washing machine door is
locked to prevent it from being
2
opened accidentally. To avoid any
damages to lock mechanism,
you must wait for the lamp to
extinguish, before attempting to
open the door which takes
around three minutes.
F
D E G H
B A
I