Instructions For The Fitter - Indesit WME 6 X Instructions For Installation And Use Manual

Mounting the wooden panel
onto the door and inserting
the machine into cabinets:
In the case where the machine
must be shipped for final
installation after the wooden
panel has been mounted, we
suggest leaving it in its original
packaging. The packaging was
designed to make it possible to
mount the wooden panel onto
the machine without removing it
completely (see figures
below).
c h e ri a
la v a b ia n
m a c h in e
w a s h in g
la v e r
m a c h in e
a s c h in e
w a s c h m
La to po rta
e
Do or sid
rte
Co te po
Tu r se ite
c h e ri a
la v a b ia n
m a c h in e
w a s h in g
la v e r
m a c h in e
a s c h in e
w a s c h m
La to po rta
Do or sid e
rte
Co te po
ite
Tu r se
27

Instructions for the fitter

The wooden panel that covers
the face of the machine must not
be less than 18 mm in
thickness and can be hinged on
either the right or left. For the
sake of practicality when using
the machine, we recommend
that the panel be hinged on the
same side as the door for the
machine itself - the left.
Door Mounting Accessories
(Fig. 1-2-3-4-5)
N° 2 Hinge Supports
Fig. 1
N° 1 Magnet
Fig. 3
N° 1 Rubber plug
Fig. 5
- No. 6 type A self-threading
screws, l =13 mm.
- No. 2 type B metric,
countersunk screws, l =25; for
fastening the magnet plate to the
cabinet.
- No. 4 type C metric screws,
l =15 mm; for mounting the hinge
supports to the cabinet.
- No. 4 type D metric screws,
l =7 mm; for mounting the hinges
on the supports.
N° 2 Hinges
Fig. 2
N° 1 Magnet plate
Fig. 4
N° 1 Spacer
Fig. 4/B