Advertisement
Available languages
Available languages
Here I'm in command
Making the right choice is important. And it's easy.
Programme selector knob
Use this dial to select one of the
15 wash programmes available
for all your laundry requirements
(see programme table on page
16).
Remember that this dial
should be turned in a
clockwise direction and only
when the machine is off.
Temperature control knob
It is used to set the wash tem-
perature indicated in the
programme table. It also allows
you to reduce the temperature
recommended for the selected
programme, and even to set a
cold wash cycle ( ).
Detergent dispenser
It is divided into three
compartments:
1. Detergent for pre-wash;
2. Detergent for the main cycle
wash;
3. Fabric conditioner.
The detergent dispenser is here.
Instructions for installation and use
15
C
Anti-crease
This button allows you to
interrupt the programme (on
symbol ), keeping the washing
soaking in water before the spin
cycle. It is a very useful button,
because it prevents delicate
and synthetic fabrics from
creasing (for example, when
you cannot take the washing out
at the end of the wash cycle but
only after a few hours).
It can only be used in
programmes for synthetic
fabrics and for wool.
ATTENTION! Before opening
the door, you must drain the
water by setting knob A to
symbol
. If, on the other hand,
you prefer to carry on with the
spin cycle, just press button D
again.
Spin Exclusion
Use this button to exclude the
spin cycle. This function should
be used for items that are
difficult to iron.
3
2
1
Understanding the control panel
D
F
E
H
G
Extra economy
Reduces water consumption
during the rinse cycles. We
recommend that you use this
function only with small laundry
loads, dosing the detergent
proportionally.
On-off
When button G is pressed, the
washing machine is switched
on, when it is not the machine
is switched off.
The on-off lamp
When this is lit, the machine is
on.
The door block lamp
The safety lamp indicates that the
washing machine door is locked
to prevent it from being opened
accidentally. To avoid any
damages to lock mechanism,
you must wait for the lamp to
extinguish, before attempting to
open the door which takes around
three minutes.
I
A
B
Advertisement
