Table of Contents
Advertisement
1
ON/OFF :
Press this button to turn on the unit. Press this button again to turn off the unit.
2
MODE :
Each time you press this button, a mode is selected in a sequence that goes from AUTO, COOL, DRY, FAN,and
HEAT *, as the following:
AUTO
*Note:Only for models with heating function.
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not be displayed on the
LCD, and the unit will automatically select the suitable operation mode in accordance with the room temperature
to make indoor room comfortable.
3
Press this button to decrease set temperature. Holding it down above 2 seconds rapidly decreases set temperature.
In AUTO mode, set temperature is not adjustable.
4
Press this button to increase set temperature. Holding it down above 2 seconds rapidly increases set temperature.
In AUTO mode, set temperature is not adjustable.
5
FAN
This button is used for setting fan speed in the sequence that goes from AUTO,
Auto.
:
6
●
Press
button to start or stop up & down swing function.The remote controller defaults to simple swing condition.
Press + button and
blinking 2 seconds.
●
In static swing condition, press
●
●
If the unit is turned off during swing operation,the louver will stop at present position.
7
HEALTH SAVE:
Press HEALTH part of this button to turn on or off HEALTH function.
Pressing SAVE part of this button,
part of the button again to cancel SAVE function. During SAVE operation, the temperature and fan speed is not
adjustable.
8
:
Press
button to start or stop left & right swing function.The remote controller defaults to simple swing
●
condition.
COOL
FAN
DRY
.
Auto
Medium speed
Low speed
button at the same time at unit OFF to switch between simple swing and static swing,
button, the swing angle of up & down horizontal louver changes as below:
OFF
is displayed and the unit goes into SAVE operation mode. Press SAVE
*
HAET
High speed
,
, to
, then back to
Hide quick links:
Advertisement
Table of Contents
