System Set-Up; Realignment - Kenwood TK-7302 Service Manual

TK-7302/7302 V /7302H/7302H
( )
Merchandise received
License and frequency allocated by FCC
Choose the type of transceiver
Transceiver programming
KES-3
External speaker
1. Modes
User mode
PC mode
Clone mode
Mode
User mode For normal use.
Used for communication between the trans-
PC mode
ceiver and PC.
PC programming Used to read and write frequency data and
mode other features to and from the transceiver.
Used to check the transceiver using the PC.
PC test mode
This feature is included in the FPU.
PC tuning mode Used to tune the transceiver using the PC.
Used to transfer programming data from one
Clone mode
transceiver to another.
4
V
( )

SYSTEM SET-UP

KCT-60
Connection cable
(Option)
KCT-18
Ignition sense cable
See page 7.
Delivery

REALIGNMENT

PC programming mode
PC test mode PC tuning mode
Function
Frequency range (MHz)
136~174
136~174
136~174
See page 4.
A personal computer, programming interface (KPG-46/46A), and
programming software (KPG-124D) are required for programming.
(Option)
See page 6.
KCT-36
Extension cable
(Option) (Option)
KES-5
External speaker
See page 7. See page 7.
2. How to Enter Each Mode
Mode
User mode
PC mode
Clone mode
3. PC Mode
3-1. Preface
The transceiver is programmed using a personal com-
puter, a programming interface (KPG-46/46A), USB adapter
(KCT-53U) and FPU (programming software).
The programming software can be used with a PC. Fig-
ure 1 shows the setup of a PC for programming.
3-2. Connection procedure
1. Connect the transceiver to the computer using the inter-
face cable and USB adapter (When the interface cable is
KPG-46A, the KCT-53U can be used.).
RF power
Type
25W TK-7302/7302(V) M/K
TK-7302H K,M
50W
50W TK-7302H(V) K
(Option)
Operation
Power ON
Received commands from PC
[ ]+Power ON (Two seconds)