System Set-Up; Realignment - Kenwood TK-P721 Service Manual

Merchandise received
Choose the type of transceiver
Transceiver programming
Are you using the optional antenna?
Are you using the speaker microphone?
1. Modes
User mode
PC mode
PC test mode
Wireless clone mode
Firmware version information mode
Self-programming mode
Mode
User mode For normal use.
Used for communication between the trans-
PC mode
ceiver and PC.

SYSTEM SET-UP

A personal computer, programming interface (KPG-22A/22U),
and FPU (programming software) are required for programming.
(The frequency, TX power HI/LOW, and signaling data are
programmed for the transceiver.)
YES
NO
YES
NO
Delivery

REALIGNMENT

Data programming mode
PC tuning mode
Function
Frequency range (MHz) RF power
TX/RX 136~174 5.0W
KRA-22 or KRA-26
Optional antenna
KMC-21, KMC-45 or KMC-48GPS
Speaker microphone
(Option)
Mode
Data programming Used to read and write frequency data and
mode other features to and from the transceiver.
Used to check the transceiver using the PC.
PC test mode
This feature is included in the FPU.
Wireless clone Used to transfer programming data from one
mode transceiver to another.
Firmware version
Used to confi rm the internal fi rmware version.
information mode
Self-programming You can program the frequency signaling and
mode other function using only the transceiver.
2. How to Enter Each Mode
Mode
User mode
PC mode
Wireless clone mode
Firmware version
information mode
Self-programming mode
TK-P721
Type
TK-P721
Function
Operation
Power ON
Received commands from PC
[<B] + Power ON (Two seconds)
[Side1] + [Side2] + Power ON (Two
seconds)
[S] + Power ON (Two seconds)
3