Kenwood TK-7302 Service Manual page 7

2. Ignition Sense Cable (KCT-18: Option)
The KCT-18 is an optional cable for enabling the ignition
function. The ignition function lets you turn the power to the
transceiver on and off with the car ignition key.
2-1. Installing the KCT-18 (Ignition sense cable) in
the transceiver
1. Remove the ACC. cap on the rear of the transceiver.
2. Connect the D-sub connector of the KCT-60 to the D-sub
15-pin terminal of the transceiver.
3. Insert the crimp terminal of the KCT-18 to pin 2 on the
15-pin connector of the KCT-60.
Note: You must setup using the KPG-124D(K) or KPG-
124D(M).
KCT-60
2
Crimp terminal
of the KCT-18
TK-7302/7302
INSTALLATION
3. External Speaker (Option)
3-1. KES-3
The KES-3 is an external speaker for the 3.5-mm-diameter
speaker jack.
■ Connection procedure
1. Remove the speaker-jack cap on the rear of the trans-
ceiver.
2. Connect the KES-3 to the 3.5-mm-diameter speaker jack
on the rear of the transceiver.
3-2. KES-5
External speaker KES-5 can be installed for KCT-60.
■ Connection procedure
1. Remove the ACC. cap on the rear of the transceiver.
2. Connect the D-sub connector of the KCT-60 to the D-sub
15-pin terminal of the transceiver.
3. Insert two crimp terminals of the KES-5 to pins 3 and 12
on the 15-pin connector of the KCT-60.
Note: You must setup using the KPG-124D(K) or KPG-
124D(M).
Black lead
V /7302H/7302H
( )
KCT-60
12
3
Black/White lead
V
( )
7