Battery Saver (Gps Save); Gps Data Setup; Land Survey System Datum; Sentence - Kenwood TH-D72A Instruction Manual

SWhen set to "GPS Only", you can operate only the
following key functions.
Key
[KEY] [F], [KEY]
Name
Continuous
[LAMP] Lamp
[ ]
[ ]
–
Menu select
[ OK]
[ESC ]
Menu
[MENU]
mode
[A/B] –
[1] MARK
GPS On/Off
[2] –
[3] POS
Function
[F]
mode

Battery Saver (GPS Save)

This function will turn the GPS power source Off
after the programmed timer expires if position data
is not determined during the maximum catching time
(approximately 5 minutes). To prevent unnecessary
battery consumption, when there are many reception
satellites, the GPS is stabilized and position data can
be determined, the GPS power source repeatedly turns
On and Off.
1 Enter Menu mode and access Menu 201.
2 Set GPS Off time to "Off", 1, 2, 4, 8, or "Auto".
Auto:
When set to Auto, the GPS Off time starts
at 1 minute for the first time, then progresses to 2
minutes, 4 minutes and 8 minutes each additional time.
The GPS Off time remains at 8 minutes thereafter.
However, after having determined your position for the
duration, if the GPS cannot pinpoint your location, the
GPS Off time will restart at 1 minute.
Note:
Position precision may be improved by setting the Batter
Saver (GPS Save) function to "Off".
You cannot set the SBAS function to "On" when the Batter
Saver (GPS Save) function is 1, 2, 4, 8, or Auto. Set the
Battery Saver (GPS Save) function to "Off".
[KEY] (1s)
Lamp
Lamp On
Function/
–
RF power
–
select
– –
Register
Internal mode
of Mark
Waypoint
Starting
the LOG –
function
– –
– –
GPS Data PC Output
Turn this function on when you want to send the
Internal GPS receiver data (NMEA) from the PC
[KEY] +
terminal using.
Power ON
1 Enter Menu mode and access Menu 202.
–
–
2 Set PC Output to "Off" or "On".
–

GPS DATA SETUP

–

Land Survey System Datum

When using the Internal GPS receiver, set up the
necessary land surveying system.
–
For APRS, select "WGS-84" (world land surveying
system).
– 1 Enter Menu mode and access Menu 210.
–
Reset mode
2 Set Datum to "WGS-84".
•

Sentence

Adds an NMEA sentence to the Internal GPS receiver
data output from the PC.
1 Enter Menu mode and access Menu 211.
2 Set Sentence to "$GPGGA", "$GPGLL", "$GPGSA",
"$GPGSV", "$GPRMC", "$GPVTG", or $GPZDA".
•
•
GPS – 3
This function does not work when using an external
GPS receiver.
With BEACON transmission, the "$GPGGA"
"$GPRMC" check ( ) cannot be removed in
necessary information and satellite image information.
You cannot output an NMEA sentence from an
external GPS receiver to a PC.