Remote Control Preparation - Carrier Air Conditioner Owner's Manual

REMOTE CONTROL PREPARATION

Replacing Batteries
1
Remove the cover of the battery compartment at the back of the remote control by sliding it out.
2
Remove the old batteries and insert the new batteries. The remote control uses two alkaline batteries.
(1.5V, LR03x2)
3
Press the RST button with a sharp object to reset the remote control before closing the cover of the battery
compartment.
• Do not fit used batteries or batteries of different type. Such use may cause the unit to malfunction.
• Changing batteries should be done after turning off the unit.
• The average battery life during normal use is one year approximately.
• When the air conditioner does not operate normally after replacing the batteries, remove the batteries,
refit them and repress the RST button after 5 seconds.
Signal Receiving
Use the remote control where its signal can reach the receiver of the air conditioner.
- You can hear the beeping sound from the unit in the remote control operation, which indicates that
the signal is received.
CAUTION
• The air conditioner will not operate if curtains, doors or other materials block the signals from the remote control to
the unit.
• If the infrared signal receiver on the unit is exposed to direct sunlight, the air conditioner may not work properly.
Draw the curtains to avoid direct sunlight.
• Avoid spilling liquid onto the remote control or dropping it. This can cause deformation, dislocation and malfunction.
• A mounting bracket for the remote control is supplied with the unit. Install the mounting bracket on the wall by
using two sharp point wood screws and/or double sided tape attached on the back of the bracket. This prevents
the remote control from being lost.
NOTE
'
OWNER S GUIDE - 8