HP ProLiant DL580 Generation 3 User Manual page 67

1. Power down the server ("Powering down the server" on page 37).
2. Remove all hard drives ("Removing a hot-plug SCSI hard drive" on page 64)
and hard drive blanks ("Removing a hard drive blank" on page 63).
3. Extend the server from the rack ("Extending the server from the rack" on
page 38).
4. Remove the access panel ("Removing the access panel" on page 40).
5. Install the SAS controller. Refer to the directions provided with the controller
for installation instructions.
6. Route and connect the power cable to the power cable connector.
CAUTION: When routing cables, always be sure that the cables
are not in a position where they can be pinched or crimped.
7. Route the SAS cables through the opening near the SCSI backplane and over
the center wall.
Hardware options installation 67