40
HP ProLiant DL580 Generation 3 Server User Guide
Removing the access panel
1. Extend the server from the rack, if applicable ("Extending the server from the
rack" on page 38).
2. If the locking latch is locked, use a Torx T-15 screwdriver to unlock the
latch.
NOTE: The release latches will lock into place when the rails are
fully extended.
WARNING: To reduce the risk of personal injury from hot
surfaces, allow the drives and the internal system components to
cool before touching them.
CAUTION: Do not operate the server for long periods with the
access panel open or removed. Operating the server in this manner
results in improper airflow and improper cooling that can lead to thermal
damage.
IMPORTANT: When removing the access panel to view QuickFind
diagnostic LEDs, leave the server powered on. The QuickFind
diagnostic LEDs are cleared when the server is powered off.
NOTE: The T-15 Torx screwdriver is shipped with the server and
can be located on the rear panel ("Rear panel components" on page
16).