•
If the mode selected is the desired mode, modify the DIMM or board
configuration to support the desired mode. For more information, refer to
"Memory Options (on page 95)."
•
If the mode selected is not the desired mode, run RBSU and change the AMP
mode. For more information, refer to the section "HP ROM-Based Setup
Utility (on page 125)."
Processor module LEDs
PPM LED (1)
Processor LED
(2)
Off
Off
Off
Amber
NOTE: If the Spare, Mirrored, and RAID LEDs are off, the server is
in Advanced ECC mode. Refer to "HP ROM-Based Setup Utility (on
page 125)" for more information.
External health
LED
Off
Flashing amber
Server component identification
Description
One of the following conditions exist:
•
No AC power present
•
Normal
Pre-failure error threshold exceeded; LEDs will
clear after the next reboot
15