Panasonic WV-SC385 Installation Manual page 19

• 12 V DC power supply terminal
q Loosen the screw of the power cable plug (accesso-
ry).
w Connect the output cable to the power cable plug.
Strip 3 mm to 7 mm {1/8 inches to 9/32 inches} from
the end of the wire, and twist the stripped part of the
wire sufficiently to avoid short circuit.
Specification of cable (wire): 16 AWG - 24 AWG,
Single core, twisted
* Check whether the stripped part of the wire is not
exposed and is securely connected.
e Tighten the screw of the power cable plug.
(Recommended tightening torque:
0.34 N·m {0.25 lbf·ft})
r Connect the power cable plug to the 12 V DC power
supply terminal on the rear of the camera.
* ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY
(UL 1310/CSA 223) or LIMITED POWER SOURCE
(IEC/EN/UL/CSA 60950-1).
–
Power cable plug
(accessory)
Important:
• The 12 V DC power supply shall be insulated from the
commercial AC power.
• Be sure to use the power cable plug provided with
this product.
• Be sure to fully insert the power cable plug into the
12 V DC power supply terminal. Otherwise, it may
damage the camera or cause malfunction.
• Be sure to use an AC adaptor compliant with the
Specifications regarding power source and power
consumption (☞ page 33).
Strip range
Approx. 3 mm - 7 mm
{1/8 inches - 9/32 inches}
+
Step 9
After completing the cable connections, attach the deco-
rative cover (accessory).
q Align the indication "OPEN" of the decorative cover to
the decorative cover guide of the camera mount
bracket.
w Rotate the decorative cover clockwise into the mount
bracket until the "LOCK" indications on both sides of
the cover reaches the decorative cover guide of the
mount bracket.
LO CK
O P E
N
Important:
• Make sure that no cable is pinched by the decorative
cover.
Decorative cover guide
LO C K
O P E
N
Decorative cover (accessory)
Decorative
cover guide
LOCK OPEN
LOCK OPEN
19