Kenwood KDC-X869 Instruction Manual page 56

Troubleshooting Guide
MP3/WMA source
?
Cannot play an MP3/WMA.67
The media is scratched or dirty.69
Clean the media, referring to the CD cleaning of the section on
<About CDs> (page 9).
?
The sound skips when an MP3/WMA is being
The media is scratched or dirty.
Clean the media, referring to the CD cleaning of the section on
<About CDs> (page 9).
The recording condition is bad.73-2
Record the media again or use another media.
?
The MP3/WMA track time isn't displayed
---
There are times when it isn't displayed correctly according to the
MP3/WMA recording conditions.
If the following situations, consult your nearest service
center:
Even though the disc changer is connected, the Disc Changer source is not
ON, with "AUX1" showing in the display during the Changer Mode.
The messages shown below display your systems
condition.
Eject:
played.73-1
No Disc:
TOC Error:
correctly.80
E-05:
Blank Disc:
No Track Disc:
E-15:
No Panel:
E-77:
Mecha Error:
E-99:
— 56 —
No disc magazine has been loaded in the changer. The disc
magazine is not completely loaded.E01
Load the disc magazine properly.
No CD in the unit.
Insert the CD.
No disc has been loaded in the disc
Load a disc into the disc magazine.
No disc has been loaded in the disc
Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD is
scratched a lot.
Clean the CD and load it correctly.
The CD is upside-down.E05
Load the CD correctly.
Nothing has been recorded on the MD.E10
No tracks are recorded on the MD, although it has a
Media was played that doesn't have data recorded that the
unit can play. E15
Use media that has data recorded that the unit can play.
The faceplate of the slave unit being connected to this unit
has been removed.E30
Replace it.
The unit is malfunctioning for some
Press the reset button on the unit. If the "E-77" code does
not disappear, consult your nearest service center.
Something is wrong with the disc magazine. Or the unit is
malfunctioning for some reason.E99
Check the disc magazine. And then press the reset button
on the unit. If the "Mecha Error" code does not disappear,
consult your nearest service center.
The unit is malfunctioning for some
Press the reset button on the unit. If the "E-99" code does
not disappear, consult your nearest service center.
magazine.E02
magazine.E04
title.E11
reason.E77
reason.E99A