Connecting Wires To Terminals - Kenwood KDC-X869 Instruction Manual

Connecting Wires to Terminals

If no connections are made, do not let the wire come out from the tab.
4 When using the optional power amplifier,
connect to its power control terminal.
5 Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
7 To car light control switch
8 To "EXT.AMP.CONT." terminal of the amplifier
having the external amp control function.
Ignition key
switch
Car fuse
box
(Main fuse)
42
Battery
43
12 Non-fading right output (Red)
49 Non-fading left output (White)
13 Front right output (Red)
14 Front left output (White)
FM/AM antenna input
Power control wire (Blue/White)
P.CONT
ANT CONT
Motor antenna control wire (Blue)
ILLUMI
Dimmer control wire (Orange / White)
EXT.
External amplifier control wire
CONT.
(Pink / Black) (KDC-X969/X869 only)
41
ACC 44
Car fuse box 45
Ground wire (Black) - (To car chassis)
+ –
15
3a
Fuse (10A) 27
Ignition wire (Red) 46
Battery wire (Yellow)
48
— 50 —
Rear right output (Red)
Rear left output (White)
AUX right input (Red)
AUX left input (White)
To KENWOOD disc changer/
Sirius satellite radio tuner/
External optional accessory
To connect these leads,
refer to the relevant
instruction manuals.
Wiring harness
(Accessory1)22
28
White/Black
To front left
+ speaker 29
White
30
31
Gray/Black
To front right
+ speaker 32
Gray
33
34
Green/Black
To rear left
+ speaker 35
Green
36
37
Purple/Black
To rear right
+
speaker 38
Purple
39
11
10