Listening To An Ipod/Iphone - JVC KD-A925BT Instructions Manual

Menu item
Connect Phone*
Connect Audio
Disconnect Phone/
Disconnect Audio
Delete Pairing
Phonebook Trans
Set PIN Code
Auto Connect
Initialize
Information
*
1 Will not display if two Bluetooth phones are connected at the same time.
* 2
Displayed only when a Bluetooth phone/audio player is connected.

Listening to an iPod/iPhone

You can connect an Apple iPod/iPhone using the USB 2.0 cable (accessory of the iPod/iPhone) to
the USB input terminal on the control panel or USB cable from the rear of the unit.
~
] Turns on the power.
Playback starts automatically.
18 ENGLISH
Selectable setting, [ Initial: Underlined ]
/ Turn the control dial to select a device you want to connect. "Connected [Device Name]"
1
appears on the display when the device is connected.
Turn the control dial to select a device you want to disconnect. "Disconnected
[Device Name]" appears on the display when the device is disconnected.
Turn the control dial to select the device you want to delete, then press the control dial to
confirm. (page 13)
You can copy the phonebook memory of a mobile phone into the unit (via OPP). You may
need to enter the PIN code or verify passkey from the mobile phone to do pairing. You can
transfer a maximum of 400 numbers.
You can change the PIN code of your choice before pairing (1-digit to 6-digit number).
[ Initial: 0000 ]
Turn the control dial to select a number, press 4
position, then press the control dial to confirm the entry.
On : The connection is established automatically with the registered Bluetooth device when
you turn on the unit. / Off : The unit does not connect the Bluetooth device automatically.
Use <Connect Phone/ Connect Audio> to connect.
Yes : Initialize all the Bluetooth settings (including stored pairing, phonebook, and etc.). /
No : Cancels.
My BT Name : Shows the unit name (JVC Unit). / My Address : Shows address of
USB Bluetooth Adapter. / ConnectedPhone *
ConnectedAudio *
Ÿ
Apple iPod/iPhone
2 : Shows connected phone name. /
2 : Shows connected audio device name.
USB input terminal
USB 2.0 cable (accessory
of the iPod/iPhone)
/¢ to move to the entry
and/or
USB cable from the
rear of the unit