Panasonic TH-98LQ70U Operating Instructions Manual page 64

■
DIGITAL LINK Terminal connection
A twisted pair cable transmitter, such as the
Panasonic Digital Interface Box (ET-YFB100G), uses
twisted pair cables to transmit inputted video and
audio signals, and these digital signals can be input to
the Display via the DIGITAL LINK terminal.
Back of the Display
COMPUTER
LAN Terminal
LAN cable (not supplied)
Example: Panasonic ET-YFB100G
Hub or broadband router
Note
●
When using a DIGITAL LINK connection, set each
item in [Network settings]. (see page 52)
●
The Panasonic Digital Interface Box (ET-YFB100G)
does not correspond to 4K signal.
64
English
Precautions for use while connecting with a twisted
pair cable transmitter
About installation / connection
●
Ask the dealer or a qualified technician to carry out
the cable wiring work for DIGITAL LINK connections.
Insufficient wiring work may cause the inability to
apply the cable transmission characteristics and
cropped or fuzzy images and sounds.
● The transmission distance between the twisted pair
cable transmitter and the device is up to 100 meters.
Exceeding this distance can cause cropped images
or sounds, as well as LAN communication errors.
● Do not use a hub between the twisted pair cable
transmitter and the device.
● When connecting the Display using the twisted pair
cable transmitter (receiver) of other manufacturer,
do not use another twisted pair cable transmitter
between the twisted pair cable transmitter of other
manufacturer and this device. The images and
sounds may be interrupted or become unstable.
● If possible, lay the cable extended and not coiled in
order to minimize both external and internal noise.
● Lay out cables of the twist pair cable transmitter and
this product away from other cables, especially from
the power supply cable.
● When laying multiple cables, keep them together as
close as possible running parallelly and not bundled.
● After laying the cable(s), check that the signal quality
in [DIGITAL LINK status] is -12 dB or below.
About Twisted pair cables
●
Between the twisted pair cable transmitter and
the device, use a LAN cable that conforms to the
following conditions.
It meets or exceeds CAT5e standards
•
It is a straight cable
•
It is a shielded cable (with a connector)
•
It is a solid cable
•
● When laying the cable(s), use an instrument such as
a cable tester or cable analyser and check whether
the cable characteristics are CAT5e or above. When
using a relay connector along the path, also include
this in the measurements.
●
Do not pull cables hard. Also, avoid bending or folding
them forcefully.
Other
●
This device is compatible with our Digital Interface
Box (ET-YFB100G). For the twisted pair cable
transmitter of the other maker, see the web site:
http://panasonic.net/prodisplays/support/digitallink.html