Panasonic TH-98LQ70U Operating Instructions Manual page 34

[H-position] Adjust the horizontal position with
[H-size] Adjust the horizontal size with
[V-position] Adjust the vertical position with
[V-size] Adjust the vertical size with
[Dot clock] (During PC input signal)
Periodic striped pattern interference
(noise) may occur when a striped pattern
is displayed. If this happens, adjust so
that any such noise is minimized.
[Clock (During PC input signal)
phase]
In some cases, frame of the screen
appears blurred or smudged, when RGB
signal or PC signal are input.
[Clamp (During PC input signal)
position]
Adjusts the clamp position when black
parts of the image have no detail due to
underexposure or are tinged with green.
Optimum value for Clamp Position
adjustment
When black parts have no detail due to
underexposure (blackout)
●
Value that causes least blackout is the
optimum.
When black parts are tinged with green
●
Value that cancels the greenishness
without causing blackout is the
optimum.
34
English
. [Over scan]
.
.
.
Note
●
In some cases, noise appears outside the area
picture is displayed, but it is not a malfunction.
Turn image over scan On/Off.
Configurable signals are as follows:
525i, 525p, 625i, 625p, 750/60p, 750/50p
(Component Video, RGB, DVI-D, SDI,
HDMI)
1125 (1080) / 60i, 50i, 60p, 50p, 24p,
25p, 30p
[On]
Note
● This menu cannot be adjusted during
4K mode.
● When [Off] is set, [H-size] and [V-size]
cannot be adjusted.
[Off]