Disabling The Password Function; Correcting Keystone - BenQ MP776 User Manual

Disabling the password function

To disable password protection, go back to the SYSTEM SETUP: Advanced > Security
Settings > Power On Lock menu after opening the OSD menu system. Press MODE/
ENTER. The message "INPUT PASSWORD" displays. Enter the current password.
i. If the password is correct, the OSD menu returns to the Security Settings page.
Press
have to enter the password next time when turning on the projector.
ii. If the password is incorrect, the password error message displays lasting for three
seconds, and the message "INPUT PASSWORD" displays for your retry. You can
press MENU/EXIT to cancel the change or try another password.
Though the password function is disabled, you need to keep the old password in hand should
you ever need to re-activate the password function by entering the old password.

Correcting keystone

Keystoning refers to the situation where the projected image is noticeably wider at either the
top or bottom. It occurs when the projector is not perpendicular to the screen.
To correct this, besides adjusting the height of the projector, if you want the projector to
automatically correct image keystoning, be sure the Auto Keystone function in the DISPLAY
menu is On.
Or you will need to manually correct it following ONE of these steps.
• Using the remote control
Press /
to display the Keystone correction page. Press
correct keystoning at the top of the image. Press
to correct keystoning at the bottom of the image.
• Using the OSD menu
1. Press MENU/EXIT and then press
the DISPLAY menu is highlighted.
2. Press
MODE/ENTER. The Keystone correction page
displays.
3. Press
the image. Press
the bottom of the image.
28 Operation
to highlight Power On Lock and press
on the projector or remote control
to highlight Keystone and press
to correct keystoning at the top of
to correct keystoning at
/
to
/ until
Press
to select Off. You will not
/ .
Press
/ .