Procedure - Fujitsu DL 3750+ User Manual

USING SETUP MODE
< < F U N C T I O N > >
SAVE&END MENU1
V-ALMNT
< C N T - O R G >
1/6IN 1.8/6IN
10/6IN 11/6IN
5-40

Procedure

Before adjusting a print position, you should carefully measure the amount
of adjustment required for any paper that demands precise print registration.
To adjust a print position, make sure that continuous forms paper is loaded.
The following example shows how to adjust the top-of-form setting for
continuous forms.
1. Enter setup mode.
Press the TEAR OFF button and the ONLINE button simultane-
ously until the printer beeps. Wait for the printer to stop printing
and check that the following <<FUNCTION>> menu is printed:
MENU2 HARDWRE ADJUST
2. Select the ADJUST function.
Repeatedly press the LOAD button or the LF/FF button to position
the red cursor under ADJUST. Press the MENU button or the
TEAR OFF button to select the ADJUST function and print the
following
<CNT-ORG> options:
2/6IN 3/6IN 4/6IN
....
3. Select an option from 1/6IN to 66/6IN.
Press the LOAD button or the LF/FF button to move the cursor to
the required option. Press the MENU button to select the option
and print the <CNTFINE> item. If necessary, fine-tune the top-of-
form position now. Otherwise, go to step 4.
4. Exit the ADJUST function.
Press the ONLINE button to exit the ADJUST function and reprint
the <<FUNCTION>> menu.
CONFIG DEFAULT LIST
5/6IN 6/6IN 7/6IN
SELF-TST HEX-DUMP
8/6IN 9/6IN
User's Manual