Printing The Self-Test - Fujitsu DL 3750+ User Manual

SETTING UP
2-14
2. Raise the cut sheet stand. Move the left paper guide all the way to the
right. Insert the sheet of paper into the cut sheet stand. Letter or A4
size paper, inserted lengthwise (portrait mode) with this setting, will
not result in clipping.
Adjust the right paper guide so that the paper lies flat on the cut sheet
stand.
3. Slide the paper along the cut sheet stand until its bottom edge touches
the platen. Then press the LOAD button. The paper will advance to
the top-of-form position.

Printing the Self-Test

The printer has a built-in self-test program. The self-test prints the firmware
version, the names of the printer's resident emulations, and all of the charac-
ters available in the emulations. The self-test prints 80 characters per line.
To print a self-test page, make sure that a sheet of paper is loaded. Then
proceed as follows:
1. Turn the printer off.
2. While pressing the LF/FF button, turn the printer back on. Keep the
LF/FF button pressed until the printer beeps. Self-test printing will
start.
User's Manual