Table of Contents
Advertisement
SETTING UP
2-24
To select an emulation, proceed as follows:
1. Turn the printer on and load a sheet of paper.
To change a single printer setting, such as the emulation, you can use
a single sheet paper. To change several printer settings as described in
Chapter 5, you must load continuous forms paper. See Chapter 3 for
paper loading instructions.
2. Enter setup mode.
Press the ONLINE button to place the printer offline. Then, press the
TEAR OFF button and the ONLINE button.
As the printer enters offline setup mode, it prints the following
information:
<<FUNCTION>>
menu
Red cursor on print guide
Initial printout in setup mode
Check that the <<FUNCTION>> menu is printed at the bottom of the
page.
Function
User's Manual
Advertisement
Table of Contents
