Important–
Save for local electrical inspector's use.
Measure cabinet area and prepare
it according to illustrations in
Minimum Clearances to
Combustible Surfaces and Range
and Cabinet Dimensions section in
this manual.
Remove the packing
materials and locate
the anti-tip bracket,
screws and plastic
anchors.
Anti-tip Bracket Installation
To avoid risk of range tipping, secure
range with a properly installed anti-
tip bracket.
1. Remove storage drawer.
2. Unscrew rear leveling legs so
they extend at least ¼ inch to
engage bracket.
3. Move range to where it will be
installed.
4. Position anti-tip bracket. With
range in position, reach through
storage drawer opening and
slide anti-tip bracket on either
left or right rear leveling leg.
Slide leg into V-shaped notch in
bracket.
5. Mark location of side and front
of anti-tip bracket on floor.
6. Remove anti-tip bracket and
range from opening.
7. Position anti-tip bracket
according to lines marked on
floor, mark 2 hole locations in
anti-tip bracket, remove bracket
and drill 2 holes.
• If drilling into wood, use a
3
/
" drill bit. If drilling into
32
concrete or tile, use a
masonry drill bit and insert
plastic anchors.
8. Secure bracket to floor using
screws supplied.
3
/
"
16