Connecting Cables To Terminals - Kenwood Z920DVD Instruction Manual

Connecting Cables to Terminals

To the monitor unit
Connection cable (Accessory8)
PRK SW
To parking brake detection
switch harness of car
2 CAUTION
To KDS-P901
For the sake of safety, be
sure to connect the parking
sensor.
To KENWOOD disc changer/ DAB control input/
KPA-SD100
NOTE
To connect these leads, refer to the relevant
instruction manuals.
Rear right input (Red)
Rear left input (White)
Fuse(10A)
Amplifier unit
NOTE
Match the cable
colours and
connect.
Ground cable (Black) - (To car chassis)
PARKING
Fuse(5A)
Front left input (White)
Front right input (Red)
Wiring harness
(Accessory1)
RCA cable (Accessory7)
B
A
Battery cable (Yellow)
Ignition cable (Red)
A–7 Pin (Red)
A–4 Pin (Yellow)
8 6
Connector A
7 5
8 6
Connector B
7 5
— 67 — — 67 —
Centre unit
To KDS-P901
FM/AM antenna input
Wiring harness
(Accessory5)
Antenna Conversion Adaptor (ISO–JASO) (Accessory3)
External amplifier control cable
(Pink / Black)
EXT.
CONT.
TEL mute cable (Brown)
TEL MUTE
Power control/ Motor antenna
control cable (Blue/White)
P.CONT
ANT.
CONT.
4 2
NOTE
3 1
If no connections are
4 2
made, do not let the cable
3 1
come out from the tab.
Front right output (Red)
A
Front left output (White)
Rear right output (Red)
B
Rear left output (White)
Non-fading right output /
Right preout (Red)
Non-fading left output /
Left preout (White)
AUX right input (Red)
AUX left input (White)
Antenna Cord (ISO)
To "EXT.AMP .CONT." terminal of the amplifier
having the external amp control function.
Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
NOTE
To connect the KENWOOD navigation
system, consult your navigation manual.
Connect either to the power control terminal
when using the optional power amplifier, or to
the antenna control terminal in the vehicle.