Connecting Cables To Terminals - Kenwood KDC-5070R Instruction Manual

Connecting Cables to Terminals

Antenna Conversion Adaptor (ISO–JASO) (Accessory3)
Antenna Cord (ISO)
Connector Function Guide
Pin Numbers for
Cable Colour
ISO Connectors
External Power
Connector
A–4 Yellow
A–5 Blue/White
A–6 Orange/White
A–7 Red
A–8 Black
Speaker
Connector
Purple
B–1
Purple/Black
B–2
Gray
B–3
Gray/Black
B–4
White
B–5
B–6 White/Black
B–7 Green
B–8 Green/Black
FM/AM antenna input
Functions
Battery
Power Control
Dimmer
Ignition (ACC)
KENWOOD disc changer
Earth (Ground)
/ DAB control input
Connection
NOTE
To connect the Disc
changer or DAB unit,
+
Rear Right ( )
consult each manual.
–
Rear Right ( )
+
Front Right ( )
–
Front Right ( )
+
Front Left ( )
–
Front Left ( )
+
Rear Left ( )
Battery cable (Yellow)
–
Rear Left ( )
Ignition cable (Red)
A–4 Pin (Yellow)
Connector A
Connector B
Front right
Fuse (10A) output (Red)
Rear right
output (Red)
Wiring harness
(Accessory1)
TEL mute cable (Brown)
If no connections are made,
do not let the cable come
out from the tab.
A–7 Pin (Red)
Power control/ Motor
antenna control
cable (Blue/White)
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
— 32 —
Rear left output
(White)
Front left
output (White)
Connect to the terminal that is
grounded when either the
TEL MUTE
telephone rings or during
conversation.
NOTE
To connect the KENWOOD
navigation system, consult
your navigation manual.
Connect either to the power
ANT.C
control terminal when using the
P.CONT
optional power amplifier, or to
the antenna control terminal in
the vehicle.