1. Remove cylinder head. See Section 2.
2. Remove oil pan, timing cover, gears, and
case. See Section 3.
3. Remove flywheel and rear seal retainer. See
Section 4.
4. Remove starter motor (Figure 1).
Figure 1
5. Remove alternator bracket and alternator
(Figure 2).
Figure 2
6. Remove valve lifters (Figure 3).
NOTE: Number lifters so that they may be
reinstalled in the same position.
Figure 3
7. Remove camshaft (Figure 4).
NOTE: Use care when removing camshaft to
prevent damaging cam bearing, journals, and lobes.
Figure 4
8. Remove oil pick-up tube and strainer (Figure
5). Discard gasket.
5
41