Figure 6
5. Remove oil pan screws and nuts.
6. Remove oil pan and discard gasket.
7. Remove oil pick-up tube (A, Figure 7) and
strainer. Discard gasket.
Figure 7
8. Remove bell housing adapter screw (if
equipped) and install Flywheel Holder
#19418 (A, Figure 8).
NOTE: Leave tool installed.
9. Remove crankshaft pulley using Crankshaft
Puller #19420 (B).
Figure 8
10. Remove trigger (Figure 9) and wire. Remove
timing gear cover and discard timing gear
gasket.
Figure 9
11. Remove camshaft timing gear (A, Figure 10).
12. Remove idler gear (B).
NOTE: It is not necessary to remove idler gear
shaft.
13. Check that oil pump turns freely by rotating
gear (C) by hand.
14. Remove oil pump drive gear.
15. Disengage flywheel holder.
12
139