Figure 36
8. Install regulator with screws (A, Figure 37).
Figure 37
9. Assemble cover (A, Figure 38) to brush
holder.
Figure 38
10. Install brush holder.
NOTE: Length of brush retainer screws are
different.
• Screw #1 - 0.45 in. (11.5 mm) (A, Figure
39).
• Screw #2 - 0.35 in. (9.0 mm) (B).
Figure 39
11. Install rear cover and screws (A, Figure 40).
Torque to values listed in Section 14 -
Engine Specifications.
12. Install insulator and nut (B) and torque to
value listed in Section 14 - Engine
Specifications.
Figure 40
13. Torque drive pulley using the following
procedures:
• Hold nut (A, Figure 41) with SST#.
• With torque wrench, turn 10 mm deep
socket COUNTERCLOCKWISE. Torque
to value listed in Section 14 - Engine
Specifications.
11
125