Operating Procedure - Pacific energy BROADWAY Installation And Operating Instructions Manual

OWNER'S
INFORMATION
IFC Module
The Proflame 2 Integrated Fireplace Control (IFC) board is a device that allows the automatic
ignition and pilot flame supervision, to command the functions of a hearth appliance. It is
configured to control the ON/OFF main burner operation, giving the choice of both IPI (intermittent
pilot ignition), and CPI (continuous pilot ignition) modes.
The Proflame 2 IFC board controls and connects directly to the pilot assembly and an automatic
valve of the Proflame 880, 886 and 885 families using low electric power.
The IFC Board can be powered by an AC and battery pack for back up (ATMO Systems only). The
Proflame 2 offers the added ability to control the comfort fan speed from OFF through six (6)
speeds, a remotely actuated auxiliary outlet and a dimmable light outlet. The external batteries can
provide DC power to the IFC allowing the batteries to be used only when line power is interrupted
or lost.

OPERATING PROCEDURE

Initializing the System for the first time
Install the 4 AA batteries into the battery box. Note the polarity of the battery and insert into the
battery box as indicated on the Battery cover (+/-). Set the main ON/OFF and the CPI/IPI switch in
the closed position. Press the program button on the IFC module. The IFC will "beep" three (3)
times to indicate that it is ready to synchronize with a Transmitter. Install the 3 AAA type batteries in
the battery bay, located on the base of the Transmitter. With the batteries installed in the
Transmitter, push the ON button. The Receiver will "beep" four times to indicate the Transmitter's
command is accepted. If a second Transmitter must be registered it can be turned ON. The
receiver will beep again four (4) times and exit the synchronization phase. If only one transmitter is
used, then press again the button program to exit the synchronization phase.
The system is now initialized.
8