Operating Procedure - Pacific energy BROADWAY Installation And Operating Instructions Manual

OWNER'S
INFORMATION
IFC Module
The Proflame 2 Integrated Fireplace Control (IFC) board (Fig. 3) is a device located at the rear
side of the fireplace or stove, that allows the automatic ignition and pilot flame supervision, and to
command the functions of a hearth appliance. It is configured to control the ON/OFF main burner
operation via a hand-held transmitter unit (Fig. 1), giving the choice of both IPI (intermittent pilot
ignition), and CPI (continuous pilot ignition) modes.
The Proflame 2 IFC board controls and connects directly to the pilot assembly and the automatic
valve of the Proflame 880, 886 and 885 families using low electric power.
The IFC Board can be powered by an AC and battery pack for back up (ATMO Systems only). The
Proflame 2 offers the added ability to control the comfort fan speed from OFF through six (6)
speeds, a remotely actuated auxiliary outlet and a dimmable light outlet. The external batteries can
provide DC power to the IFC allowing the batteries to be used only when line power is interrupted
l

OPERATING PROCEDURE

Initializing the
Install the 4 AA batteries into the battery box located on the rear of the fireplace (Fig. 4). Note the
polarity of the battery and insert into the battery box as indicated on the Battery cover (+/-). Set the
main ON/OFF switch to remote. Press the program button on the On/Off switch. The IFC will "beep"
three (3) times to indicate that it is ready to synchronize with a Transmitter. Install the 3 AAA type
batteries in the battery bay, located on the base of the hand held Transmitter. With the batteries
installed in the Transmitter, push the ON button. The IFC will "beep" four times to indicate the
Transmitter's command is accepted. If a second Transmitter is to be registered, it can be turned
ON. The IFC will beep again four (4) times and exit the synchronization phase. If only one
transmitter is used, then press the program button again to exit the synchronization phase. The
system is now initialized.
Figure 3. IFC (integrated
fireplace control) module.
020215-36
Figure 4. On/Off switch. Position switch
in the middle to use the hand-held remote
control switch.
Figure 5. On/Off switch cover
8 5055.66-E