Table of Contents
Advertisement
Item
Reset Button
e
Video Output Port
f
IR LED
g
Illumination Sensor
h
Wipe out a dirty surface of the lens softly with a lens tissue or cloth to which you have applied
`
M
ethanol.
Resets the camera settings to the default.
Press and hold for about 5 seconds to reboot the system.
If you reset the camera, the network settings will be adjusted so that
J
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
Connected to the monitor so that you can check the video from the camera.
(for installation)
These infrared LED's are controlled by the illumination sensor.
Detects incoming light to control the IR LED.
Description
English _13
Advertisement
Table of Contents
