This Appliance Must Be Earthed - Baxi Solo 3 PFL 30 User Operating Instructions Manual

WARNING: If it is either known or suspected that a fault exists on the
appliance, it must not be used until the fault has been corrected by a
competent person.
Benchmark Commissioning Checklist
Please ensure that the installer has fully completed the Benchmark Checklist on the
inside back pages of the installation instructions supplied with the product and that
you have signed it to say that you have received a full and clear explanation of its
operation. The installer is legally required to complete a commissioning checklist as a
means of complying with the appropriate Building Regulations (England and Wales).
All installations must be notified to Local Area Building Control either directly or
through a Competent Persons Scheme. A Building Regulations Compliance Certificate
will then be issued to the customer who should, on receipt, write the Notification
Number on the Benchmark Checklist.
This product should be serviced regularly to optimise its safety, efficiency and
performance. The service engineer should complete the relevant Service Record on
the Benchmark Checklist after each service.
The Benchmark Checklist may be required in the event of any warranty work and as
supporting documentation relating to home improvements in the optional documents
section of the Home Information Pack.
1
© Baxi Heating UK Ltd 2009
1.0 Warnings
1.1 Safe Installation
The appliance is suitable only for installation in GB and
IE and should be installed in accordance with the rules in
force.
In GB, the installation must be carried out by a Gas
Safe Registered Installer. It must be carried out in
accordance with the relevant requirements of the:
• Gas Safety (Installation & Use) Regulations.
• The appropriate Building Regulations either The
Building Regulations, The Building Regulations
(Scotland), Building Regulations (Northern Ireland).
• The Water Fittings Regulations or Water Byelaws in
Scotland.
• The Current I.E.E. Wiring Regulations.
Where no specific instructions are given, reference
should be made to the relevant British Standard Code
of Practice.
In IE, the installation must be carried out by a
competent Person and installed in accordance with the
current edition of I.S. 813 'Domestic Gas Installations',
the current Building Regulations and reference should
be made to the current ETCI rules for electrical
installation.
Read the instructions before installing or using this
appliance.
WARNING: Sealed components must not be
interfered with.
Never hang clothes or other items over the
appliance.
1.2 In case of gas leaks
1. If a gas leak is found or suspected, turn off the gas
supply at the meter immediately and call your gas
supplier.
1.3 Servicing your boiler
1. We strongly recommend that your Boiler is serviced
annually by a competent person for economic and safety
reasons. Your Installer will be able to advise you.
1.4 Electricity supply

1. THIS APPLIANCE MUST BE EARTHED

A standard 230 volt ~ 50Hz supply is required. The
appliance must be protected by a 5 amp fuse.
3