Kenwood RC-2000 Instruction Manual page 30

GROUP C–2
VOX
Refer to VOX in the USB/ LSB section {page 22} .
V GAIN
Refer to V GAIN in the USB/ LSB section {page 22}.
V DLY
Refer to V DLY in the USB/ LSB section {page 22}.
NAR
Press to select FM narrow bandwidth operation. "FMN"
appears when you operate FM narrow bandwidth.
RF
Refer to RF in the CW section {page 24}.
GROUP C–3
CTCSS
Press to activate the CTCSS function. Press and hold
the key to select your desired CTCSS tone using the
[c]/ [d] keys or by turning the MULTI/ CH control, then
press either [EXIT] or the MULTI/ CH control to change
the setting. Press [SCAN] to start the CTCSS Freq. ID
Scan.
TONE
Press to activate the TONE function.
26
DCS
Press to activate the DCS function. Press and hold the
key to select your desired DCS code using the [c]/ [d]
keys or by turning the MULTI/ CH control, then press
either [EXIT] or the MULTI/ CH control to change the
setting. Press [SCAN] to start the DCS code ID Scan.
ALT
Press to activate the Auto Lock Tuning (ALT) function
(1.2 GHz band only). When it is ON, "
SHIFT
Press to select the desired repeater shift direction. "–",
"+", or "=" appears to indicate the shift direction.
GROUP C–4
N.R.
Refer to N.R. in the USB/ LSB section {page 22}.
T.SEL
Press to select your desired TONE frequency using the
[c]/ [d] keys or by turning the MULTI/ CH control, then
press either [EXIT] or the MULTI/ CH control to change
the setting. Press [SCAN] to start the TONE ID Scan.
M.B.C.
Refer to M.B.C. in the CW section {page 24}.
FILTER
Refer to FILTER in the CW section {page 24}.
" appears.