Kenwood RC-2000 Instruction Manual page 21

M.IN
Press to enter the Memory Scroll mode {TS-2000
page 60}. "MSR" appears on the display. Turn the
MULTI/ CH control to select your desired memory
channel number. Press [M.IN] to write the data to
memory. You can also press [MN.IN] to enter and select
the Memory Name and Memory Group. Select your
desired character using the MULTI/ CH control, or the
[b]/ [a] and [DEL] keys. Press [OK] to store the
Memory Name. Press [G-SEL] to enter the Memory
Group selection. Select a desired Memory Group using
the MULTI/ CH control or [b]/ [a] keys, then press
[SEL]. Press [OK] to store the new Memory Group
selection.
V/M
Press to select either VFO or Memory Recall mode
{TS-2000 page 59}. In Memory Recall mode, "tM" or
"Ms" appears on the display. Turn the MULTI/ CH
control to select your desired memory channel.
GROUP A–5
A–5 functions appear only when recalling Memory
Channels 290 ~ 299 {TS-2000 page 62}.
SET
Turn the Tuning control and press [SET] to set the
frequency point of Program Scan Partially Slowed on the
main transceiver {TS-2000 page 67}. The " " icon
appears on the display when you tune to the marked
frequency. Press and hold the key to clear all the
frequency points that you have configured.
OPEN
Press to confirm the start frequency when you recall a
memory channel from 290 ~ 299 {TS-2000 page 62}.
CLOSE
Press to confirm the end frequency when you recall a
memory channel from 290 ~ 299 {TS-2000 page 62}.
17