Kenwood KVT-M700 Instruction Manual page 39

Installation for Receiver unit
■
Securing to audio board
1
Attach the installation brackets to the sides of the
hideaway unit using the sems bolts (M4 × 8 mm).
Sems bolts (M4 × 8 mm)
(Accessory F)
Do not install the receiver unit under the carpet. Otherwise heat build-
up occurs and the unit may be damaged.
Removing Monitor Unit
■
Removing the Hard Rubber Frame
1
Engage the catch pins on the removal tool and remove
the two locks on the lower level.
Lower the frame and pull it forward as shown in the
figure.
(Accessory K)
■
Removing the Unit
1
Refer to the section "Removing
the Hard Rubber Frame" and then
remove the hard rubber frame.
2
Remove the screw (M4×6) on the
back panel.
3
Insert the two removal tools
deeply into the slots on each side,
as shown.
Installation brackets
(Accessory H)
Lock Catch
4
Lower the removal tool toward
the bottom, and pull out the unit
halfway while pressing towards
the inside.
Be careful to avoid injury from
the catch pins on the removal
tool.
Catch facing up
2
Use the tapping screw (ø4 × 16 mm) to
secure the hideaway unit to the audio board.
(ø4 × 16 mm) (Accessory G)
2
When the lower level is removed, remove the upper
two locations.
The frame can be removed from the top side in the
same manner.
5
Pull the unit all the way out with
your hands, being careful not to
drop it.
39